Atlassian uses cookies to improve your browsing experience, perform analytics and research, and conduct advertising. Accept all cookies to indicate that you agree to our use of cookies on your device.

Results will update as you type.

DISPLAY TOUCH SCREEN AND BMS GATEWAY ENABLING
REMOTE CONTROL
DOT DISPLAY NETWORK SETTINGS
INTRODUCTION TO ZONES
ZONE ACTIVATION AND WORK MODE
ZONE SET POINT AND SENSOR SETTING
CONNECTED ZONES
ZONES IN SPECIAL WORK MODE
ZONES IN ANTIFREEZE MODE
HOW DO ZONES AFFECT CIRCUITS?
HOW DO ZONES AFFECT DEHUMIDIFIERS?
USING THE FORCE CONTROL SIGNAL
DEW POINT MANAGEMENT
DUCT UNIT MANAGEMENT SUMMING MORE 0/10 REQUESTS
DEHUMIDIFICATION AND INTEGRATION FUNCTION
INTEGRATION OFFSET
CMV FUNCTION WITH TIMETABLE AND/OR VOC SENSOR
ECONOMY FUNCTION FOR THE DEHUMIDIFIERS
MANAGE > 8 FAN COIL WITH 0/10V
SET POINT AND SENSORS SETTINGS
FATHER CIRCUIT AND INTERLOCKED CIRCUIT
WATER PUMPS AND MIXING VALVES SETTINGS
SOURCES SETTING IN THE CIRCUIT PAGE
AMBIENT COMPENSATION
HOW TO USE REG SYSTEM TO MANAGE BOILER ROOMS
SOURCES INTRODUCTION
ENABLE OR ACTIVE SOURCE?
SOURCES PRIORITY
DEGRADED SOURCE
DATA RECEIVED FROM OPENTHERM GENERATORS
HEATING/COOLING OPENTHERM
BUFFER TANK COMPENSATION TEMPERATURE
DHW OPENTHERM
PID CASCADE ALGORITHM
POWER CASCADE
DHW ENABLE
DHW SET POINT
DHW ASSOCIATED CIRCUIT
ANTI-LEGIONELLA MANAGEMENT
DHW CIRCULATION MANAGEMENT
USE A ZONE AS DHW SUBSYSTEM
DHW AND SURPLUS FUNCTION
SOLAR THERMAL PANELS WITH ONE TANK
SOLAR THERMAL PANELS WITH TWO TANKS
INSTANT DHW PRODUCTION MANAGEMENT
FREE DRY SIGNAL AND TEMPERATURE MEASURES
LOGIC/BOOLEAN FUNCTIONS
MATH FUNCTIONS
ENERGY METERS AND MONITORING
EN_10. BOLLETTINO TECNICO - PAGINA SEGNALI LIBERI
ALARMS
BUS REG WIRING BEST PRACTICE

You‘re viewing this with anonymous access, so some content might be blocked.

USE A ZONE AS DHW SUBSYSTEM

Edited Sept 19, 2023

USE A ZONE AS DHW SUBSYSTEM

, Edit

Within the Zones – Configuration Zone / 3 page it is possible to associate one or more zones with the DHW Special Mode instead of the Seasonal mode:

In this case, the hysteresis is taken from DHW Page and the global enable is that of DHW (not heating/cooling) on the Configuration 1 Page. This zone, being used for the DHW, will always activate below the set point and it will deactivate above the current set point + hysteresis.

For all other characteristics (set point, surplus mode, circuit assignment, etc) you can consider the same ones specified for the zones.