Associated Sensor
Normally a temperature (or temperature and humidity) sensor is associated to a zone via the Sensor parameter on the Configuration Zone/1 sub page:
...
The Temperature and Humidity value of the selected sensor can be visualized on the left of the Zone page.
Note
Remember that a zone can also operate without associated sensor; in this case, when the zone is active (in Comfort, Economy, or Antifreeze Active mode), the corresponding output will be always active. Some possible uses of this configuration are:
...
The humidity management logic, with control of the dehumidifiers
Dew point control logic.
For dew point managementcontrol logic, see DEW POINT MANAGEMENT.
...
The current set temperature is on the left side of the Zone Page.
Note
From version 4.30 of the REG Firmware, a new Function is available, which also allows you to manage a humidity economy set point (see ECONOMY FUNCTION FOR THE DEHUMIDIFIERS).
...
Limits are set on Configuration 1 page:PHOTO TBD
...
Warning
If RegConfig is used, these limits are bypassed, while they can’t be bypassed by REG-TFT and REG-DOT-B display and by REG-THL-SXX sensors
...
Temperature and Humidity hysteresis are also set equal for all the zones in Configuration 1:PHOTO TBD
...
So, if the set point of a zone is 21°C, the zone will activate below 21°C and will deactivate above 21,3°C in heating. If the humidity set point is 55%, the zone (if it has a humidity sensor) will activate the dehumidification request above 55% and deactivate it below 50%.
...