Page Comparison

...

2. The same Virtual Command can be assigned to several physical outputs; for example:

   1. The Virtual Commands “System in Summer mode”, which is activated when the Current Season is set to “SUMMER”, can be applied simultaneously to several relays, for example one to switch the Working Mode of a heat pump, and the other to switch the position of a diverting valve.

   2. In systems with very large surfaces, it may happen that the electro-thermal headers of the same zone are positioned in different manifolds controlled by different expansions boards; in this case, the same control of “Command Zone” can be applied simultaneously to the relays of one and the other expansions.

   3. In systems with more than one fancoil fan coil in a room, it is possible to manage the speed of the fancoils fan coils with the same Analogue Virtual Command by assigning them to different physical analogue outputs, even located on different boards.

3. For some Digital Virtual Commands the system also provides Virtual Command with the opposite function; for example:

   1. The system provides the Virtual Command “System in SUmmer Summer Mode”, which is activated when the Current Season is set on “SUMMER”, and also it opposite, “System in Winter mode”; if the use of a contact is require to switch the operating mode of a heat pump, we must check whether the heat pump interprets sees the closed contact as summer or winter; in the first case, we will assign the Virtual Contact “System in Summer mode”, to the relay, in the other “System in Winter mode”.

4. In cases where the opposite signal of a Digital Virtual Command is required, and this is not already made available,

   it is possible to create the opposite of any Virtual Command via the

...

2. LOGIC/

...

2. BOOLEAN FUNCTIONS, in

...

2. praticular using the NOT function.

3. The Digital Virtual Commands can be virtually used as digital input of the REG System itself, see

...

2. ere ANALOG AND DIGITAL INPUT MULTIPLEXER in the

...

2. digital Input Selector VDoutL e VDout H part.

It is attached the Annex II of the REG System Manual, where all digital and analogue outputs available from the firmware and from the RegConfig version 4.32 are listed.

1. Per alcuni Comandi Virtuali Digitiali il sistema mette a disposizione anche Comando Virtuale con la funzione opposta; per esempio

   1. Il sistema prevede Comando Virtuale "Impianto in modo Estate", che si attiva quando la Stagione Corrente è impostata su "ESTATE", ed anche il suo opposto, "Impianto in modo Inverno"; se si richiede l'uso di un contatto per commutare il modo di funzionamento di una pompa di calore, dovremo verificare se la pompa di calore interpreta il contatto chiuso come estate o come inverno; nel primo caso assegneremo al relé il Contatto Virtuale "Impianto in modo Estate", nell'altro "Impianto in modo Inverno".

2. Nei casi in cui sia richiesto il segnale opposto di un Comando Virtuale Digitale, e questo non sia già reso disponibile dal sistema, è possibile creare l'opposto di un qualunque Comando Virtuale tramite le LOGIC/BOOLEAN FUNCTIONSe in particolare usando la funzione NOT.

3. I Comandi Virtuali digitali possono essere utilizzati virtualmente come ingresso digitale del Sistema REG stesso, vedere ANALOG AND DIGITAL INPUT MULTIPLEXER nella parte Selettore Ingresso Digitale VDoutL e VDout H

Di seguito si allega l’allegato II del Manuale del Sistema REG dove sono elencate tutte le uscite digitali e analogiche disponibili dalla versione firmware e di RegCinfig 4.32.

...