Which sources to enable at any given time depends on the following factors:
...
The position of the 6 parameters listed above is shown in the following screenshot:
...
Warning
Do not use the Auxiliary sensor!
...
In the last section at the bottom of each source there is a summary which at a glance shows whether the source is enabled, active, in cooling mode and whether the external and water temperatures are within the source’s enabling ranges:PHOTO TBD
...
There is also a comparison between the desired temperature coming from the circuits (set point) and the temperature of the sensor used, if present (Current Actual Temperature).
The current speed Actual Output corresponds to the set point that would be sent to the source if a 0/10V set point output were connected.
...
From 56 to 59 are the same for source 2 and from 60 to 63 for source 3.PHOTO TBD
...
AVAILABLE ANALOGUE OUTPUTS
...
For source 2 is the output 18, 19 for source 3.PHOTO TBD
...