This section shows valid values only if connecting via USB cable directly to the REG-DOT-B, if connecting to the REG-DIN-8 do not use it:
PHOTO TBD
Within this section there are some parameters that cannot be changed, such as:
...
While other parameters are changeable, such as the network to which the device connects, the status of the WiFi modem within the DOT and network parameters (DHCP, IP, DNS etc.):
...
STATO DEL MODEM WIFI
...
WIFI MODEM STATUS
It is possible to switch the WiFi Modem on or off within the DOT with the following commands to be entered in Modem Request, while in the first box of the Current Status you can see the status of the modem at that moment. If the request is equal to the status, it means that the modem has received the command:
...
Nel caso sia presente una REG-LAN-MK2 o un REG-GSM il WiFi del DOT deve essere in OFF.
·
WIFI OFF: the display modem is switched off (Modem request from RegConfig = 1);
...
WIFI ACTIVE DISCONNECTED: the display WiFi modem is switched on, but it does not look for the access point of the network to which it should connect (Modem request from RegConfig = 2);
...
WIFI ACTIVE CONNECTED: the display WiFi modem is switched on and it attempts to connect to the access point of the network, but it does not attempt to reach remote management portal (Modem request from RegConfig = 4);
...
ONLINE: the display modem is switched on; it searches for the access point of the network and if it connects to the customer’s modem it attempts to communicate with the remote management portal (Modem request from RegConfig = 6).
These 4 states correspond to as many buttons within the Modem Management menu that is shown in the DOT display.
...
Nel caso in cui sia necessario che il router assegni anche i DNS allora impostare DHCP = 2. Se invece si vogliono inserire manualmente i parametri di rete allora impostare il DHCP a zero.
Attenzione
Ogni volta che si cambiano i parametri di rete bisogna prima mettere il WiFi del DOT in OFF e poi riaccenderlo.
...
L’SSID di rete è il nome della rete WiFi a cui ci si vuole collegare e relativa password.
Attenzione
Non lasciare spazi prima o dopo il nome della rete o la password!
...
If it is necessary for the router to also assign the DNS, then set DHCP = 2. If, on the other hand, you wish to manually enter the network parameters, then set DHCP to zero.
Warning
Every time the network parameters are changed, you need to set the DOT’s WiFi to OFF and then switch it on again.
...
The network SSID is the name of the WiFi network you wish to connect to and its password.
Warning
Do not leave spaces before or after the network name or password!
...